Hot wire cutter ThermoCut 12/E with power source MicroMot NG 2/E (hobby - set)
What is it?
Our tip - we recommended this product. It is fully tested, function is 100%
Action or new product - attractive product with super price or our new product
Stock - this product is at stock in orinary event. You can verify state before order
Hand held hot wire cutter ThermoCut 12/E is fit for free modelling in Styrofoam and polystyrene. Architecture modelling, prototype construction, for designers, decorators, or for fine work on construction insulation. It is no problem for ThermoCut 12 E. We have this cutter with power source MicroMot in one price.
For cutter 12 / E: Input: 60 W (from power source NG-2/E) Voltage: 12 V DC Hot wire temperature: 150 - 350°C (regulated) Proportions of cutting wire: 285 x 0,85 mm Warm-up: to 1 sec. Extension: max. 200mm Work piece height: max. 150 mm
Weight: 360 g. Proportions: min. 280 x 165 x 40 mm
For power source NG 2 / E: Input voltage: AC 220 - 240V, 50 Hz Max. amperage: 2.0 A No load output voltage: 16 V DC Load output voltage: 12 V DC El. insulation: class 2
Weight: 1000 g. Proportions: 140 x 85 x 70 mm
No "crumbling" as found when working with traditional tools.
Cutter ThermoCut 12/E Stable frame with pivotable fixing element at top and extendable lower wire fixing. Maximum total extension 200mm. Maximum work piece height 150mm.
Cutting wire temperature infinitely variable. With a little practice, you can achieve optimum cuts depending on the material density and thickness. Usually at medium temperatures and without too much pressure. Heat-up time 1 second. Complete with five deformable cutting wires 285 x 0.85mm.
Power Source MicroMot NG 2/E 12/E This power source is fit for ThermoCut 12/E
Polarised socket for MICROMOT plug. Red LED indicates readiness for use. PTC (Positive temperature coefficient) element prevents overload (and plugged in tool will not automatically restart). After cooling down the mains plug should be disconnected briefly to reset the adapter. With holes for storing bits. Foldable tool rest provides a secure place for keeping the MICROMOT tools at the ready. Variable speed control with feedback effect for adjusting bit speed to suit the job, as well as providing high torque at low speeds.